| | | | 
| Hem welding with the Uniplan |
UNIPLAN Hem Welding Machine Start with exchanging the pressure belt.
 Then, loosen and remove the belt pressure system.
 After removing the pressure belt system, you do the same with the guide roller lever.
 Now you can screw off the hub retaining sheet
 and loosen the locking screw which fixes the dowel pin.
 Loosen the locking screw until you can easily remove the dowel pin.
 After removing the dowel pin, you can take away the guide roller,
 and replace the roller set.
 Then, re-fix the dowel pin and make sure that the milled surface lies where the locking screw makes contact.
 Insert the dowel pin again and secure it with the locking pin.
 Now put the hem guide onto the undercarriage,
 and fix it with the two screw, which hold the hubs of the retaining sheet.
 Finally, fix the additional weight according to the operating manual of the UNIPLAN and start welding.
 Click here to download the PDF instructions |  Click here to join our newsletter
MARK YOUR
CALENDARS
for these special events!
WSRCA Trade Show
See the new Varimat V2 in the following booths
Booth #'s 603, 605, 607, 609, Island C, Island J
Paris-Las Vegas Hotel & Casino
June 20-23
Booth #TBA
SGIA
Las Vegas Conv. Center
October 13-15 2010
Booth #TBA
Pack Expo 2010
Chicago IL
October 31- November 3 2010
| |
